You are watching: How to make a soldering iron with a screwdriver
Lets start now for the materials.
● 2 AA BATTERIES
● BATTERY HOLDER
● COPPER WIRE
● FIBER GLASS TAPE
● NICHROME WIRE
Lets walk for the steps!1st. Step cut off a little piece that copper wire
2nd. Cut a piece of fibre glass tape
3rd. Wrap the pieces of tape to copper wire
4th wrap the nichrome wire
5th. Make a sling at the finish of the copper wire, together u deserve to see ~ above the snapshot below.
6th. Placed the washer and screw the on the block.
7th. Usage gluegun to placed the block come the battery holder
8th. Solder the wire to the swich and connect it come the copper wire.
9th. Use gluegun to put the move at the back of the batt holder.
10th. THE SOLDERING stole IS READY!
INSERT THE BATTERY then SWITCH that ON
As you have the right to see yes sir a smoke comes out, that is beacause the nichrome cable is burn the copper wire us left on. (The smoke will certainly fade in a minutes)
Thats it . Start soldering best away.
I make my very own too!
I make the efforts to take it a photo on my an extremely own steps however my camera is a shit, i will shot to make this again when i gained home.
See more: What Is Steph Curry With A 40 Inch Vertical ", Steph Curry With A 40 Inch Vertical
¤if girlfriend dont have actually a nichrome wire use the nichrome wire inside the used light bulb.